approach path

英 [əˈprəʊtʃ pɑːθ]

美 [əˈproʊtʃ pæθ]

进场航线

电力

英英释义

noun

• the final path followed by an aircraft as it is landing
  Synonym:approachglide pathglide slope

双语例句

• The problems of the approach glide& down path holding and longitudinal control are particularly discussed. At the same time, the ways to calculate the feedback control loop parameters for automatic flight control system and approach power compensator system are given.
  着重讨论了舰载飞机在进场下滑过程中的轨迹保持及其纵向控制，同时给出了此时飞机的飞行自动控制系统和进场功率补偿器系统反馈控制参数的计算方法。
• Chapter 4, according to the shortage of the algorithm provided in the chapter 3 and removing the influence of unsureness sensors information, a feasible mixed approach of path planning is discussed.
  第四章针对第三章提出算法的缺点，排出不确定传感器信息的影响，试验一种随机规划与局部路径规划相结合的混合路径规划方法。
• Research of dynamic time warping approach based on path constraint
  基于路径约束的动态时间规整方法研究
• An efficient approach of the shortest path algorithm which is based on Dijkstra algorithm is realized. A motorcade-optimized dispatching software is realized.
  用Dijkstra算法实现了城市中两点间最短路径搜索，在此基础上，实现了基于电子地图的大型车队优化调度及管理的系统软件。
• With this approach, a repository path is sufficient to describe a location.
  这种方式下，库路径就可以充分的表述位置了。
• In conclusion, it provides a new approach to forecast the path of tropical and changes of the intensity.
  从而为热带气旋路径的预报以及强度变化的预测提供了新的方法。
• Transition Cost Matrix Based Approach to Robot Path Planning
  基于转移费用矩阵的机器人路径规划方法
• Ms. Hersman stressed that there was 'no prior distress call' from the cockpit crew, which should have been able to rely on both ground-based and onboard landing aids to 'establish an approach path' to safely reach the beginning of the runway.
  赫斯曼强调说，驾驶舱内的机组人员事发前没有发出遇险信号。机组成员原本应该能够依靠地面上和飞机上的着陆辅助系统建立一条降落通道，安全到达跑道的起点处。
• Finally, the two path planning approaches are elaborated differently, which are the Genetic Simulated Annealing path planning approach based on hierarchical model and the local path planning approach based on radar path planner.
  最后，本文分别详细介绍了全局路径规划和局部路径规划两个算法：基于分层模型的遗传模拟退火算法路径规划和基于雷达法的局部路径规划。
• Finally, a new approach for cutter path calculation using binary-search technique is presented, which will simplify the CNC programming problems to a great extent.
  最后提出一种采用对分试算法计算刀具轨迹的新方法，可简化数控编程计算问题。